Table of Contents
Advertisement
Figure 33
1. Pipe connection from the injection pump to the No. 1
injector nozzle
2. Move the throttle to the F
3. Turn the ignition key the S
fuel flow around the connector.
CAUTION
The engine may start during this procedure.
Moving fans and belts in a running engine can
severely injure you or bystanders.
Keep hands, fingers, loose clothing/jewelry,
and hair away from the engine fan and belt
during this procedure.
4. Tighten the pipe connector securely when it attains a
solid flow.
5. Turn the key to the O
6. Repeat this procedure for the remaining nozzles.
position.
AST
position and watch the
TART
position.
FF
Electrical System
Maintenance
Important: Whenever working with the electrical
system, always disconnect the battery cables, negative
(-) cable first, to prevent possible wiring damage from
short-outs.
Electrical System Safety
•
Disconnect the battery before repairing the machine.
Disconnect the negative terminal first and the positive
last. Connect the positive terminal first and the negative
last.
•
Battery acid is poisonous and can cause burns. Avoid
contact with your skin, eyes, and clothing. Protect your
face, eyes, and clothing when working with a battery.
•
Battery gases can explode. Keep cigarettes, sparks, and
flames away from the battery.
•
Charge the batteries in an open, well-ventilated area,
away from sparks and flames. Unplug the charger before
connecting or disconnecting the battery. Wear protective
clothing and use insulated tools.
•
Do not use a pressure washer near any electronic
components.
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Servicing the Battery
Service Interval: Every 50 hours
If you store the machine in a location where temperatures are
extremely high, the battery runs down more rapidly than if the
machine is stored in a location where the temperature is cool.
Keep the top of the battery clean by washing it periodically
with a brush dipped in ammonia or bicarbonate soda solution.
Flush the top surface with water after cleaning it.
Important: Do not remove the fill caps while cleaning
the battery.
The battery cables must be tight on the terminals to provide
good electrical contact.
If corrosion occurs at the terminals, disconnect the cables,
negative (-) cable first, and scrape the clamps and terminals
27
WARNING
Advertisement
Table of Contents
