Alarm, Error and System Messages
12.1
Boot error messages
12.1
During startup (the boot process), the BIOS first performs a Power On Self Test (POST) and
checks whether certain functional units of the PC are operating error-free. When an error
occurs within this phase, the BIOS outputs a tone sequence (beep code) based on the
current test result. The boot sequence is interrupted immediately if fatal errors occur.
If the POST does not return an error, the BIOS initializes and tests further functional units. In
this startup phase, the graphics controller is initialized and any error messages are output to
the screen.
The following lists the error messages from the system BIOS. For information on error
messages output by the operating system or programs, refer to the corresponding manuals.
On-screen error messages
On-screen error message
Address conflict
Combination not supported
IO device IRQ conflict
Invalid System Configuration
Data
Allocation Error for ...
System battery is dead.
Replace and run SETUP
System CMOS checksum bad
Run SETUP
Failure Fixed Disk
Keyboard error
Key seizure
SIMATIC Box PC 627
Operating Instructions, Release 05/2006, A5E00362052-03
Meaning / suggestions
Plug and Play problem.
Contact your technical support team.
Plug and Play problem.
Contact your technical support team.
Plug and Play problem.
Contact your technical support team.
Plug and Play Problem
Set the RESET CONFIGURATION DATA option in the
•
"Advanced" menu of Setup.
Contact your technical support team.
•
Plug and Play problem
Please undo the last hardware change.
•
Contact your technical support team.
•
The battery on the CPU module is defective or dead.
Contact your technical support team.
Call up SETUP, adjust settings and save. If this message appears
during each startup, contact your technical support team.
Error accessing the hard drive.
Check the SETUP settings.
Contact your technical support team.
Check whether the keyboard is properly connected.
Check whether a key on the keyboard has seized.
12
12-1