Chapter 3. Removing And Replacing The Rackswitch And Components; Removing And Replacing The Rackswitch Chassis Unit From A Rack; Removing The Rackswitch Chassis From A Standard Equipment Rack - IBM G8052 Installation Manual

Rackswitch

Table of Contents

Chapter 3. Removing and replacing the RackSwitch and

components

This chapter describes the how to remove and replace the RackSwitch chassis and

the associated RackSwitch components, such as, a fan module, and options, such

as, the 1U air duct option.

When replacing a RackSwitch chassis, all internal components must also be

removed from the chassis and replaced in the new chassis.

For more information to remove and replace the RackSwitch, components and

options, see the following sections.

v "Removing and replacing the RackSwitch chassis unit from a rack"

This section describes how to remove the RackSwitch chassis unit from supported

equipment racks. For information about removing the RackSwitch from different

racks, see the following sections:

v "Removing the RackSwitch chassis from a standard equipment rack"

v "Removing the RackSwitch chassis from a System x or Power rack" on page 36

v "Removing the RackSwitch chassis from an iDataPlex rack" on page 38

To remove the RackSwitch from a standard equipment rack, complete the following

steps:

1. Disconnect all cables.

2. Loosen and remove the M6 screws, washers, and clip nuts (or cage nuts) to

remove the switch unit from the rack.

Table of Contents

Show Quick Links

Table of Contents