Dell Z9500 Configuration Manual page 263
Z-series core and aggregation switche
Hide thumbs
Also See for Z9500:
- Command reference manual (1905 pages) ,
- Reference manual (1849 pages) ,
- Installation manual (47 pages)
Table of Contents
Advertisement
Admin is enabled
PG-grp Priority# BW-% BW-COMMITTED BW-PEAK TSA
% Rate(Mbps) Burst(KB) Rate(Mpbs) Burst(KB)
----------------------------------------------------------------------------------
0
0,1,2,4,5,6,7 50 400 100 4000 400 ETS
1
3
2
3
4
5
6
7
Remote Parameters :
-------------------
Remote is disabled
Local Parameters :
------------------
Local is enabled
PG-grp Priority# BW-% BW-COMMITTED BW-PEAK TSA
% Rate(Mbps) Burst(KB) Rate(Mpbs) Burst(KB)
----------------------------------------------------------------------------------
0
0,1,2,4,5,6,7 50 400 100 4000 400 ETS
1
3
50 -
2
3
4
5
6
7
Oper status is init
Conf TLV Tx Status is disabled
Traffic Class TLV Tx Status is disabled
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
0 Input Traffic Class TLV Pkts, 0 Output Traffic Class TLV Pkts, 0 Error
Traffic Class TLV
Pkts
The following table describes the show interface ets detail command fields.
Table 21. show interface ets detail Command Description
Field
Interface
Maximum Supported PG
Number of Traffic Classes
Admin mode
Admin Parameters
Remote Parameters
50 - - - - ETS
- - - - - -
- - - - - -
- - - - - -
- - - - - -
- - - - - -
- - - - - -
-
-
-
ETS
- -
-
-
- -
- -
-
-
- -
- -
-
-
- -
- -
-
-
- -
- -
-
-
- -
- -
-
-
- -
Description
Interface type with linecard and port number. The port type
can be ten gigabit or forty gigabit.
Maximum number of priority groups supported.
Number of 802.1p priorities currently configured.
ETS mode: on or off.
ETS configuration on local port, including priority groups,
assigned dot1p priorities, and bandwidth allocation.
ETS configuration on remote peer port, including Admin
mode (enabled if a valid TLV was received or disabled), priority
groups, assigned dot1p priorities, and bandwidth allocation. If
the ETS Admin mode is enabled on the remote port for DCBx
exchange, the Willing bit received in ETS TLVs from the
remote peer is included.
Data Center Bridging (DCB)
263
Advertisement
Table of Contents
Troubleshooting
