Implementing Frrp; Frrp Configuration; Creating The Frrp Group - Dell Z9500 Configuration Manual
Z-series core and aggregation switche
Hide thumbs
Also See for Z9500:
- Command reference manual (1905 pages) ,
- Reference manual (1849 pages) ,
- Installation manual (47 pages)
Table of Contents
Advertisement
Concept
Explanation
Ring Health-Check
The Master node generates two types of RHFs. RHFs never loop the ring because they terminate at the
Frame (RHF)
Master node's secondary port.
•
•
Implementing FRRP
•
FRRP is media and speed independent.
•
FRRP is a Dell proprietary protocol that does not interoperate with any other vendor.
•
You must disable the spanning tree protocol (STP) on both the Primary and Secondary interfaces before you can enable
FRRP.
•
All ring ports must be Layer 2 ports. This is required for both Master and Transit nodes.
•
A VLAN configured as a control VLAN for a ring cannot be configured as a control or member VLAN for any other ring.
•
The control VLAN is not used to carry any data traffic; it carries only RHFs.
•
The control VLAN cannot have members that are not ring ports.
•
If multiple rings share one or more member VLANs, they cannot share any links between them.
•
Member VLANs across multiple rings are not supported in Master nodes.
•
Each ring has only one Master node; all others are transit nodes.
FRRP Configuration
These are the tasks to configure FRRP.
•
Creating the FRRP Group
•
Configuring the Control VLAN
– Configure Primary and Secondary ports
•
Configuring and Adding the Member VLANs
– Configure Primary and Secondary ports
Other FRRP related commands are:
•
Clearing the FRRP Counters
•
Viewing the FRRP Configuration
•
Viewing the FRRP Information
Creating the FRRP Group
Create the FRRP group on each switch in the ring.
To create the FRRP group, use the command.
•
Create the FRRP group with this Ring ID.
CONFIGURATION mode
protocol frrp ring-id
Hello RHF (HRHF) — These frames are processed only on the Master node's Secondary port. The
Transit nodes pass the HRHF through without processing it. An HRHF is sent at every Hello interval.
Topology Change RHF (TCRHF) — These frames contains ring status, keepalive, and the control and
member VLAN hash. The TCRHF is processed at each node of the ring. TCRHFs are sent out the
Master Node's Primary and Secondary interface when the ring is declared in a Failed state with the
same sequence number, on any topology change to ensure that all Transit nodes receive it. There is
no periodic transmission of TCRHFs. The TCRHFs are sent on triggered events of ring failure or ring
restoration only.
Force10 Resilient Ring Protocol (FRRP)
356
Advertisement
Table of Contents
Troubleshooting
