Configure Pim-Ssm; Related Configuration Tasks; Enabling Pim-Ssm; Use Pim-Ssm With Igmp Version 2 Hosts - Dell Z9500 Configuration Manual
Z-series core and aggregation switche
Hide thumbs
Also See for Z9500:
- Command reference manual (1905 pages) ,
- Reference manual (1849 pages) ,
- Installation manual (47 pages)
Table of Contents
Advertisement
Configure PIM-SSM
Configuring PIM-SSM is a two-step process.
1.
Configure PIM-SSM.
2.
Enable PIM-SSM for a range of addresses.
Related Configuration Tasks
•
Use PIM-SSM with IGMP Version 2 Hosts
Enabling PIM-SSM
To enable PIM-SSM, follow these steps.
1
Create an ACL that uses permit rules to specify what range of addresses should use SSM.
CONFIGURATION mode
ip access-list standard name
2
Enter the ip pim ssm-range command and specify the ACL you created.
CONFIGURATION mode
ip pim ssm-range acl-name
Enabling PIM-SSM
To display address ranges in the PIM-SSM range, use the show ip pim ssm-range command from EXEC Privilege mode.
R1(conf)#do show run pim
!
ip pim rp-address 10.11.12.2 group-address 224.0.0.0/4
ip pim ssm-range ssm
R1(conf)#do show run acl
!
ip access-list standard ssm
seq 5 permit host 239.0.0.2
R1(conf)#do show ip pim ssm-range
Group Address
/ MaskLen
239.0.0.2
/ 32
Use PIM-SSM with IGMP Version 2 Hosts
PIM-SSM requires receivers that support IGMP version 3. You can employ PIM-SSM even when receivers support only IGMP
version 1 or version 2 by translating (*,G) entries to (S,G) entries.
Translate (*,G) entries to (S,G) entries using the ip igmp ssm-map acl command source from CONFIGURATION mode. In a
standard access list, specify the groups or the group ranges that you want to map to a source. Then, specify the multicast
source.
•
When an SSM map is in place and Dell Networking OS cannot find any matching access lists for a group, it continues to
create (*,G) entries because there is an implicit deny for unspecified groups in the ACL.
•
When you remove the mapping configuration, Dell Networking OS removes the corresponding (S,G) states that it created
and re-establishes the original (*,G) states.
•
You may enter multiple ssm-map commands for different access lists. You may also enter multiple ssm-map commands for
the same access list, as long as they use different source addresses.
•
When an extended ACL is associated with this command, Dell Networking OS displays an error message. If you apply an
extended ACL before you create it, Dell Networking OS accepts the configuration, but when the ACL is later defined, Dell
Networking OS ignores the ACL and the stated mapping has no effect.
To display the source to which a group is mapped, use the show ip igmp ssm-map [group] command. If you use the
group option, the command displays the group-to-source mapping even if the group is not currently in the IGMP group table.
PIM Source-Specific Mode (PIM-SSM)
618
Advertisement
Table of Contents
Troubleshooting
