Associating The Vlt Lag Or Vlt Vlan In A Pvlan - Dell Z9500 Configuration Manual

Z-series core and aggregation switche

Hide thumbs Also See for Z9500:

Command reference manual (1905 pages)

Reference manual (1849 pages)

Installation manual (47 pages)

Table of Contents

Enter the same port-channel number configured with the peer-link port-channel command as described in

VLT and Creating a VLT

To be included in the VLTi, the port channel must be in Default mode (no switchport or VLAN assigned).

Remove an IP address from the interface.

INTERFACE PORT-CHANNEL mode

no ip address

Add one or more port interfaces to the port channel.

INTERFACE PORT-CHANNEL mode

channel-member interface

interface: specify one of the following interface types:

For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.

For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/port information.

Ensure that the port channel is active.

INTERFACE PORT-CHANNEL mode

To configure the VLT interconnect, repeat Steps 1–4 on the VLT peer switch.

Enter VLT-domain configuration mode for a specified VLT domain.

CONFIGURATION mode

vlt domain domain-id

The range of domain IDs is from 1 to 1000.

Enter the port-channel number that acts as the interconnect trunk.

VLT DOMAIN CONFIGURATION mode

peer-link port-channel id-number

(Optional) To configure a VLT LAG, enter the VLAN ID number of the VLAN where the VLT forwards packets received on

the VLTi from an adjacent peer that is down.

VLT DOMAIN CONFIGURATION mode

peer-link port-channel id-number peer-down-vlan vlan interface number