HP 1652B Getting Started page 30

Logic analyzer

Hide thumbs Also See for 1652B:

Table of Contents

Using the State Analyzer

Introduction

In this chapter you learn how to use the state analyzer by setting up the

logic analyzer to simulate a simple state measurement. We give you the

measurement results as actually measured by the logic analyzer, since

you may not have the same circuit available.

The exercise in this chapter is organized in a task format. The tasks are

in the same order you will most likely use them once you become

experienced. The steps in this format are both numbered and lettered.

The numbered steps state the step objective. The lettered steps explain

how to accomplish each step objective. There is also an example of

each menu after it has been properly set up.

16528/16538

Using the State Analyzer

Getting Started Guide

4-I

How you use the steps depends on how much you remember from

chapters 1 through 3. If you can set up each menu by just looking at the

menu picture, go ahead and do so. If you need a reminder of what steps

to perform, follow the numbered steps. If you still need more

information about "how," use the lettered steps.

Table of Contents

1653b