Table of Contents
Advertisement
4. Remove the hairpin clip shown in figure
23.
Unhook the brake spring from the weld pin on the
idler bracket.
Auger
j
Belt
t]l_
NOTE
Figure
23 is show
with the
chute
assembly
removed
for
clarity
only.
It is not
necessary
to remove
the
chute when replacing the belts.
5. Using a 1!2" wrench, loosen upper left hand belt
guard and pivot out of the way. Remove the right
hand belt guard and cupped washer,
A 9116"
wrench is requJred.
6. Roll belt off the engine pultey.
7. Unhook the cable from the weld pin on the idler
bracket. See figure 23.
Right
Upper Left
Belt Guard
Belt Guard
pring
Weig
Transfer
Lever
FIGURE 24.
(Do Not
Remove
Weld Pin on
Idler Bracket
FIGURE 23.
8. Separate
the snow thrower
follows.
into two halves as
a. Move weight transfer
lever to the "Packed
Snow" position.
b. Using a 9/16" wrench,
remove the top bolts
which attach the auger housing to the frame
assembly. Loosen (do not remove) the bottom
bolts. See figure 24.
c. Lift up on the auger drive belt to pull the auger
housing off the frame assembly,
The snow
thrower will separate into two halves.
d. Tip the auger housing forward so it rests on the
front of the housing.
.
10.
11.
I
NOTE
Be certain to check the condition
of
the drive belt when the two halves of
the
unit
are
separated.
Replace
if
necessary.
Using a 15116" wrench, remove the four shoulder
bolts and cupped
washers
which
act as belt
keepers. See figure 25.
Roll belt off the auger pulley.
Remove the second hairpin clip from the weld pin
on the idler bracket.
!2. Push the idler to the right to extend the spring.
Remove belt from between idler pulley and weld
pin. See figure 25.
13. Reassemble new belt in reverse order.
Idler
Auger_
'X_k.-_,-=J_/'//
]_ /
Pulley
_l
"_.'\_/
!_/
Belt Keepers
FIGURE 25.
14
Hide quick links:
Advertisement
Table of Contents
