Table of Contents
Advertisement
Active LED is blinking in green and Fault LED is blinking in amber. (HDD is
rebuilding)
Removing a disk drive
1
Put on an anti-static wrist strap.
.
2
Verify the Fault LED lights on amber.
.
3
Connect Web console. See
.
section.
4
Turn on LID LED for identifying the target blade. See
.
on/off procedure on page 4-7
5
Push the lock button, as shown below, and then pull the lever.
.
6
With holding the lever of the disk drive, and remove the disk drive from
.
the server blade or storage expansion blade.
Installing a disk drive
Note: To reduce the risk of the failure for rebuilding data, wait for
approximately one minute after removing the failed disk drive.
1
Put on an anti-static wrist strap.
.
2
Reverse the removal procedure to install.
.
Note: When you removed a disk from CB 520H B2 or the storage
expansion blade, which is connected to CB 520H B2, remove the canister
bezel from the lever of the disk, and then install the bezel onto the lever
of installing disk drive before installing it into the blade.
Removing the bezel:
(1) Push a brace of the canister bezel toward the pivot of the lever.
5-36
Figure 5-43 Removing the disk drive from the server blade
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
Web console login procedure on page 4-3
section.
Identify LED (LID)
- Quick Links:
- Server Blade
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
