Table of Contents
Advertisement
Installing a mezzanine card
1
Put on an anti-static wrist strap.
.
2
If the connector cover is installed in the slot where you want to install the
.
spare mezzanine card, remove the cover from the slot first.
3
Align the three alignment holes of mezzanine card with the guide pins, as
.
shown below.
4
Reverse the removal procedure.
.
5
Configure the parameters in the case of replacing Emulex HBA card.
.
See
6
Perform
.
5-52
Figure 5-66 Removing the mezzanine card
Figure 5-67 Removing the connector cover
Configuration procedure for Emulex HBA card on page 7-2
Installing a full-wide server blade on page 5-7
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
procedure.
- Quick Links:
- Server Blade
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
