Table of Contents
Advertisement
A SAS-kit 1 is composed of:
1
HDD backplane board
.
Removing a SAS-kit 1
1
Put on an anti-static wrist strap.
.
2
Remove the target server blade.
.
See
3
Open the top cover of the server blade. See
.
blade on page 5-38
4
Slide the disk drives approximately 4 cm to disconnect with the HDD
.
backplane board.
5
Lift the HDD backplane board and remove it from the server blade
.
assembly.
Installing a SAS-kit 1
1
Put on an anti-static wrist strap.
.
2
Install the spare HDD backplane board while inserting both side panel
.
edges to the guides.
3
Reverse the removal procedure.
.
4
Perform
.
Removing a half-wide server blade on page 5-4
section.
Figure 5-112 Removing the HDD backplane board
Installing a half-wide server blade on page 5-5
Figure 5-113 Installing the HDD backplane board
Replacing parts
Hitachi Compute Blade 500 Series System Service Manual
section.
Opening a top cover, Server
procedure.
5-91
- Quick Links:
- Server Blade
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
