Table of Contents
Advertisement
Operating the Machine
Move the bypass levers rearward through the keyhole
and down to lock them in place as shown in
Note:
Do this for each lever.
Transporting the Machine
Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
necessary brakes, lighting, and marking as required
by law. Please carefully read all the safety instructions.
Knowing this information could help you, your family,
pets, or bystanders avoid injury.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents, causing personal
injury.
Do not drive the machine on a public street
or roadway.
1. If you are using a trailer, connect it to the towing
vehicle and connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Load the machine onto the trailer or truck.
4. Shut off the engine, remove the key, set the
brake, and close the fuel valve.
5. Tie down the machine near the front caster
wheels and the rear bumper
Figure 32
Figure
31.
(Figure
32).
g027708
30
Loading the Machine
Use extreme caution when loading or unloading
machines onto a trailer or a truck. Use a full-width
ramp that is wider than the machine for this procedure.
Back the machine up the ramp and drive it forward
down the ramp
(Figure
Figure 33
1. Back the machine up the
ramp.
Important:
Do not use narrow individual ramps
for each side of the machine.
WARNING
Loading a machine onto a trailer or truck
increases the possibility of tip-over and could
cause serious injury or death
• Use extreme caution when operating a
machine on a ramp.
• Use only a full-width ramp; do not use
individual ramps for each side of the
machine.
• Do not exceed a 15-degree angle between
the ramp and the ground or between the
ramp and the trailer or truck.
• Ensure that the length of ramp is at least
4 times as long as the height of the trailer
or truck bed to the ground. This ensures
that the ramp angle does not exceed 15
degrees on flat ground.
• Back up ramps and drive forward down
ramps.
• Avoid sudden acceleration or deceleration
while driving the machine on a ramp as
this could cause a loss of control or a
tip-over situation.
33).
2. Drive the machine forward
down the ramp.
(Figure
34).
g027995
Hide quick links:
Advertisement
Table of Contents
