DTD no. 41-8000
4.3
Cord Reel Replacement
Note
The cord reel and cord form one assembly and can only be replaced together.
A Cover Frame Removal, 020 4.2.
A Operating Unit Removal, 040 4.1.
A Release the right and left sides of the cord reel and lever the cord reel out,
using a flathead screwdriver as necessary.
A Reinstall by following these instructions in reverse order.
Note
When re-installing the cord reel, make sure that the seal on the motor/cord reel
wiring harness is installed correctly in its groove on the motor seal before
pressing the cord reel assembly into place.
4.4
Pre-Motor Filter Frame Removal
A Take out the cord reel, referring to Cord Reel Replacement, 050 4.3 as
necessary.
A Remove the parking slot screw (T20) on the motor side and take out the
parking slot.
A Open the pre-motor filter frame.
A Press in on the blue pins (one was obscured by the cord reel and the other by
the parking slot) using a suitable tool.
07.06.2013, US_am
Descriptive Technical Documentation
This information should not be duplicated or passed on without Miele approval. All rights reserved.
050-7