Table of Contents
Advertisement
Procedure
1. Open the Windows command prompt as administrator on the SVP.
2. In the folder where the .bat file is located, execute the following command:
C:\MAPP\wk\Supervisor\MappIniSet>MappPortRangeSet.bat port-number-
key-name port-number-range
The following table shows the port number key name and initial value of the port
number range which can be changed. Port 0 is not assigned.
Port number key name
PreRMIServer
SMIS_CIMOM
DeviceJettyStart
DeviceJettyStop
unavailable
The valid range of the port number is between 1 and 65535. Use a port number
■
that is not used in another service.
Port numbers between 1 and 1023 are reserved for the other applications. If you
■
exclude a number between 1 and 1023 from the setting value of unavailable, the
port numbers might not operate normally.
The following can be used for the port number range:
■
Numbers, space, symbols (, -) and rm
You can specify multiple port-number-key-name and port-number-range.
■
For example: MappPortRangeSet.bat PreRMIServer 51200-55000
SMIS_CIMOM 5989-6244,8000
3. Press any key to acknowledge the message and close the message box.
4. Close the Windows command prompt.
Initializing the range of an automatically assigned port number
You can initialize the range of the port number that is automatically assigned to the
storage system.
System Administrator Guide for VSP Gx00 models and VSP Fx00 models
Initializing the range of an automatically assigned port number
Note:
A space is required between MappPortRangeSet.bat and port-
■
number-key-name.
A space is required between port-number-key-name and port-number-
■
range.
Initial value of port
number range
51100 to 51355
5989 to 6244
48081 to 48336
48411 to 48666
1 to 1023
Chapter 3: Configuring the storage system
Remark
None
None
None
None
Port number that is not
used in automatic assign
63
Hide quick links:
Advertisement
Table of Contents
