Table of Contents
Advertisement
Troubleshooting
Symptom
The title search function does not
work.
The new sound added to the
recorded tape is not heard.
The title is not displayed.
The date search or title search does
not work correctly.
In the recording and playback modes
Symptom
The power does not turn on.
The end search function does not
work.
The end search function does not
work correctly.
The battery pack is quickly
discharged.
The battery remaining indicator does
not indicate the correct time.
The cassette cannot be removed from
the holder.
The % and Z indicators flash and no
functions except for cassette ejection
work.
indicator does not appear when
using a tape with cassette memory.
Remaining tape indicator is not
displayed.
Cause and/or Corrective Actions
• The tape has no cassette memory.
c Use a tape with cassette memory. (p. 138)
• CM SEARCH is set to OFF in the MENU settings.
c Set it to ON. (p. 93)
• There is no title in the tape.
c Superimpose the titles. (p. 85)
• AUDIO MIX is set to ST1 side in the MENU settings.
c Adjust AUDIO MIX in the MENU settings. (p. 93)
• TITLE DSPL is set to OFF in the MENU settings.
c Set it to ON in the MENU settings. (p. 93)
• The tape has a blank portion in the recorded portion (p. 138)
Cause and/or Corrective Actions
• The battery pack is not installed, or is dead or nearly dead.
c Install a charged battery pack. (p. 12, 13)
• The AC power adaptor is not connected to the mains.
c Connect the AC power adaptor to the mains. (p. 18)
• The tape was ejected after recording when using a tape without
cassette memory.
• You have not recorded on the new cassette yet.
• The tape has a blank portion in the beginning or middle.
• The operating temperature is too low.
• The battery pack is not fully charged.
c Charge the battery pack again. (p. 13)
• The battery pack is completely dead, and cannot be recharged.
c Replace with a new battery pack. (p. 12)
• You have used the battery pack in an extremely hot or cold
environment for a long time.
• The battery pack is completely dead, and cannot be recharged.
c Replace with a new battery pack. (p. 12)
• The battery is dead.
c Use a charged battery pack. (p. 12, 13)
• The power source is disconnected.
c Connect it firmly. (p. 12, 18)
• The battery is dead.
c Use a charged battery pack or the AC power adaptor.
(p. 12, 18)
• Moisture condensation has occurred.
c Remove the cassette and leave your camcorder for at least 1
hour to acclimatize. (p. 158)
• The gold-plated connector of the tape is dirty or dusty.
c Clean the gold-plated connector. (p. 140)
• The q REMAIN is set to AUTO in the MENU settings.
c Set it to ON to always display the remaining tape indicator.
(p. 93)
(continued on the following page)
143
Hide quick links:
Advertisement
Table of Contents
