Block Search - Siemens SINUMERIK 810M Operating And Programming Manual
Hide thumbs
Also See for SINUMERIK 810M:
- Commissioning manual (736 pages) ,
- User manual (300 pages) ,
- Equipment manual (28 pages)
Table of Contents
Advertisement
3 Operating Sequences
3.2.3 Influencing "AUTOMATIC" operation
3.2.3.3 "BLOCK SEARCH"
The "BLOCK SEARCH" function allows entry into a program at any desired point. In the
"Block search" display, you enter the program and the block number.
A block search is also possible in nested subroutines.Enter in the main program the number of
the block in which the subroutine call is programmed. After this, enter the subroutine number,
the pass count, and the block number of the subroutine.
During the block search operation, the same calculations are carried out as in normal program
operation although the axes are not traversed!
Output of the auxiliary functions during "block search"
Depending upon the setting made at the time of installation, the H-, M-, S-, and T- functions
are output either completely or in part or they are fully suppressed.
Sequence of operation
AUTO-
MATIC
and
or
BLOCK
SEARCH
3-104
can be defined in machine data.
Operate the "RESET" key on the machine
control panel.
Operate the operating mode selection key on
the integrated machine control panel, and
then the "AUTOMATIC" softkey, or ...
... set the operating mode selector switch on
the external machine control panel to this
symbol.
Extend the displayed softkey menu, and
subsequently select the "BLOCK SEARCH"
softkey function.
© Siemens AG 1990 All Rights Reserved
11.90
6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)
Advertisement
Table of Contents
