Table of Contents
Advertisement
Assembly
5.2 Installing the machine
5.2.2.1
Mounting and withdrawing output transmission elements
● When mounting output transmission elements (coupling, gear wheel, belt pulley etc. ) use
the thread at the shaft end.
● Use a suitable device when withdrawing output elements.
● When mounting or withdrawing, do not apply any blows, for example with a hammer or
similar tool, to the parts to be mounted or withdrawn.
● Only transfer radial or axial forces specified in the catalog to the motor bearings via the shaft
extension.
5.2.3
Foot mounting
Note
Only authorized retrofit partners must be employed to relocate the bolted on mounting feet at
the machine enclosure.
After attaching the mounting feet, you must note the following in order to avoid stressing and
deforming the machine.
● Ensure that the foot mounting surfaces are aligned in one plane and are parallel to the
machine shaft.
● Post-machine the foot mounting surfaces or use thin shims, for example.
46
Withdrawing output transmission elements
Mounting output transmission elements
If possible, heat up the output transmission elements as required.
1PC134, 1PC136 crane motors SH 132 ... 315
Operating Instructions, 02/2019, A5E43212221A
Advertisement
Table of Contents
