Holes Or 2 Circular Spigots - Siemens SINUMERIK 840D sl Programming Manual

Measuring cycles

Hide thumbs Also See for SINUMERIK 840D sl:

Table of Contents

2 holes or 2 circular spigots

This permits calculation of the basic rotation (rotation in the working plane) of the clamped

This enables orientation by:

• "Coordinate rotation" or

• rotation of the workpiece with a rotary table (rotary axis).

For an angle offset by "coordinate rotation", it is possible to set the reference point for the

calculated center of the 1st hole/spigot.

Measurement is performed in both axes of the working plane.

Approaching the workpiece

Position the probe roughly in the center of the 1st hole/spigot P1, after completion of this

measurement in the rough center of the 2nd hole/spigot P2, for a hole to measuring depth in

each case, for a spigot above the spigot.

Enter details in input form

• Select of the ZO

• Enter approximate diameter (hole/spigot).

• For spigots only: Enter the infeed value DZ:

Measuring cycles

Programming Manual, Release 04/2006, 6FC5398-4BP10-0BA0

This must be selected such that it applies to all holes/spigots.

(measuring depth as from starting position, value >0)

Measuring in JOG

4.2 Workpiece measurement