Table of Contents
Advertisement
Available languages
Available languages
Installation Instructions CP 1411
3.2
Installation under Windows 98, 2000 Professional
Requirement 1
Requirement 2
34
The CP 1411 communications processor must already be installed in
the PC/programming device.
The Plug and Play mechanism of the computer must be activated!
Check this on your PC/programming device. This function is normally
enabled in the BIOS.
Note:
Under Windows 98, 2000 Pro, the plug and play mechanism of the
module must be activated ("PnP Configuration").
When shipped, the plug and play mechanism of the CP 1411 is en-
abled! (You can activate or deactivate the plug-and-play mechanism
using the AMINSTAL program; see Section 3.4).
Only for Windows 2000 Professional
Please check the software settings
(taskbar Start
Settings
Connections).
Select the entry "Ethernet Adapter/ISA+ of the AMD PCNET family".
Select File
Properties to change to the Properties dialog and select
the "Advanced Settings" tab. The "Properties of Ethernet Adapter/ISA+
of the AMD PCNET family" menu appears.
Here, you can deactivate the "Full Duplex" mode (this may be neces-
sary in some circumstances).
Only for Windows 2000 Professional
AUI can be set in Windows 2000 Pro however it does not work!
Control Panel
Network and Dial-up
Section continued on the following page
Installationsanleitung CP 1411
C79000-Z8974-C24-05
Advertisement
Chapters
Table of Contents
