Wds List - Siemens SCALANCE W780 Configuration Manual
Simatic net industrial wireless lan to ieee 802.11n web based management
Hide thumbs
Also See for SCALANCE W780:
- Configuration manual (456 pages) ,
- Reference manual (84 pages) ,
- Reference manual (126 pages)
Table of Contents
Advertisement
5.4.11.3
WDS List
Communication between access points
In normal operation, the access point is used as an interface to a network and communicates
with clients. There are, however, situations in which several access points need to
communicate with each other, for example to extend wireless coverage or to set up a
wireless backbone. This mode is possible with WDS (Wireless Distributed System).
As default, the list is updated every 2 seconds. To disable the update, click "On". Instead of
"On", "Off" is displayed. As default, updating is always enabled on the WBM page.
Note
This tab is available only in access point mode.
This page shows information about the WDS connections of the access point.
Description
The table has the following columns:
● Radio
Shows the available WLAN interfaces.
● Port
Shows the port.
● BSSID
Shows the MAC address of the WDS partner.
● WDS ID
Shows the name of the WDS partner.
● Channel
Shows the channel over which the access point communicates with the WDS partner.
● Signal Strength [dBm]
Shows the signal strength of the connected access point in bBm.
● Signal Strength [%]
Shows the signal strength of the connected access point as a percentage.
● Security
Shows which authentication method is used.
If the authentication method "Open System + Encryption" or "Shared Key" is used,
"Encrypted (WEP/AES)" is displayed for both authentication methods.
SCALANCE W780/W740 to IEEE 802.11n Web Based Management
Configuration Manual, 03/2015, C79000-G8976-C267-08
Configuring with Web Based Management
5.4 "Information" menu
115
Hide quick links:
Advertisement
Table of Contents
