Adjusting The Height Of Cut - Toro Z Master Professional 5000 Series Operator's Manual
Hide thumbs
Also See for Z Master Professional 5000 Series:
- Operator's manual (92 pages) ,
- Setup instructions (16 pages) ,
- Operator's manual (76 pages)
Table of Contents
Advertisement
Adjusting the Height of Cut
Using the Transport Lock
The transport lock has 2 positions, and is used with
the deck-lift pedal. There is a L
U
position for the transport position
NLOCK
Figure 27
Transport-Lock Positions
1. Transport lock
2. L
position—mower
OCK
deck locks into transport
position
position and a
OCK
(Figure
27).
g032377
3. U
position—does
NLOCK
not lock the mower deck
into transport position
Adjusting the Height-of-Cut Pin
The height-of-cut is adjusted from 25 to 140 mm (1
to 5-1/2 inches) in 6 mm (1/4 inch) increments by
relocating the clevis pin into different hole locations.
1.
Move the transport lock to the lock position.
2.
Push on the deck-lift pedal with your foot, and
raise the mower deck to the transport position
(also the 140 mm (5-1/2 inches) cutting height
position) as shown in
3.
To adjust, rotate the pin 90 degrees and remove
the pin from the height-of-cut bracket
28).
4.
Select a hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and
insert the pin
(Figure
5.
Push on the deck lift, pull back on the transport
lock, and slowly lower the mower deck.
1. Deck-lift pedal
2. Cut-of-height pin
26
Figure
28.
(Figure
28).
Figure 28
3. Transport lock
g027343
- Quick Links:
- Servicing the Engine Oil
Hide quick links:
Advertisement
Table of Contents
