Maintenance; Maintenance Safety; Recommended Maintenance Schedule(S) - Toro Reelmaster 5610 Owner's/Operator's Manual
Traction unit
Hide thumbs
Also See for Reelmaster 5610:
- Operator's manual (68 pages) ,
- Service manual (662 pages) ,
- Service manual (304 pages)
Table of Contents
Advertisement
Maintenance
Note:
Determine the left and right sides of the machine from the normal operating position.
Maintenance Safety
•
Before you leave the operator's position, do the
following:
– Park the machine on a level surface.
– Disengage the cutting unit(s) and lower the
attachments.
– Engage the parking brake.
– Shut off the engine and remove the key (if
equipped).
– Wait for all movement to stop.
•
Allow machine components to cool before
performing maintenance.
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the first hour
After the first 8 hours
After the first 10 hours
After the first 50 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 150 hours
Every 200 hours
Every 250 hours
Maintenance Procedure
• Torque the wheel lug nuts to 94 to 122 N⋅m (70 to 90 ft-lb ).
• Check the condition and tension of the alternator belt.
• Torque the wheel lug nuts to 94 to 122 N⋅m (70 to 90 ft-lb).
• Change the engine oil and filter.
• Check the engine speed (idle and full throttle).
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the operation of the interlock switches.
• Check the engine-oil level.
• Drain water or other contaminants from water separator .
• Check the tire pressure.
• Check the cooling system.
• Remove debris from the screen, oil coolers, and radiator (more frequently in dirty
operating conditions).
• Check the hydraulic lines and hoses.
• Check the hydraulic-fluid level.
• Check the reel-to-bedknife contact.
• Grease the bearings and bushings. (Grease them immediately after every washing
regardless of the interval listed.)
• Clean the battery and check the condition of it (or weekly, whichever comes first).
• Check the battery-cable connections.
• Inspect the cooling system hoses.
• Check the condition and tension of the alternator belt.
• Change the engine oil and filter.
• Drain moisture from the fuel and hydraulic fluid tanks.
• Torque the wheel lug nuts to 94 to 122 N⋅m (70 to 90 ft-lb).
•
If possible, do not perform maintenance while the
engine is running. Keep away from moving parts.
•
Support the machine with jack stands whenever
you work under the machine.
•
Carefully release pressure from components with
stored energy.
•
Keep all parts of the machine in good working
condition and all hardware tightened.
•
Replace all worn or damaged decals.
•
To ensure safe, optimal performance of the
machine, use only genuine Toro replacement
parts. Replacement parts made by other
manufacturers could be dangerous, and such use
could void the product warranty.
31
- Quick Links:
- Recommended Maintenance Schedule(S)
Hide quick links:
Advertisement
Table of Contents
