Heat And Blower Levels - Silvercrest SHTK 2000 A1 Operating Instructions Manual
Ionic hair dryer
Hide thumbs
Also See for SHTK 2000 A1:
- Operating instructions manual (92 pages) ,
- Operating instructions manual (52 pages) ,
- Operating instructions manual (64 pages)
Table of Contents
Advertisement
Available languages
Available languages
ATTENTION! DAMAGE TO PROPERTY!
Never pull the power cord out of the device beyond the point
►
indicated with a red mark .
Always pull the power cord out of the device up to the point
►
indicated with a red mark when you use the device . Otherwise it
could overheat!
Operation
NOTE
►
Before use, pull the plug out of the device up to the point indicated with a
red mark!
Heat and blower levels
1) Insert the plug into a power socket .
2) Switch the hair dryer on with the blower level switch 5 .
The hair dryer is fitted with two function switches . With these you can separately
select the strength of the air flow (blower level switch 5) and the level of heat
(heat level switch 6):
Blower levels
0
Heat levels
3) After use, switch the appliance off in that you place the blower level switch 5
into position "0" . Then remove the plug from the wall socket .
4) Press the cord retract button 2 to feed the cord back into the device .
■
42
│
GB │ MT
The hair dryer is switched off
reduced air flow
full power air flow
cold air flow
low heating level
high heating level
SHTK 2000 A1
Advertisement
Chapters
Table of Contents
