Table of Contents
Advertisement
4.1 Data backup procedure
4.1
Data backup procedure
4.1.1
4.1.2
Yaskawa Siemens CNC series has Data in/out screens. Various data of CNC can be backed up
on these screens.
This page describes the outline of these screen. For further operation of these screens, please
refer to
Operating Manual for Machining Center" (NCSIE-SP02-25) or
"
Operator
s Guide HMI Advanced" (6FC5398-2AP10-0BA0).
'
Data in/Data out/Manage data
CNC data are displayed in form of folder tree in each screen of [Data in], [Data out] and
[Manage data] under data in/out screen.
Various data can be saved into the file with binary or punch tape format in [Data out] screen. In
addition to HDD of CNC, external storage device connected with RS-232C port, PC card/
Floppy disk and/or PC connected via network can be specified as target, if those are installed.
Saved data can be restored in [Data in] screen.
Desired data can be copied on folder tree in [Manage data] screen. In addition to HDD of CNC,
PC card/Floppy disk and/or PC connected via network can be specified as target, if those are
installed.
Series startup
The data, displayed in [Data in], [Data out] and [Manage data] screens, are actually stored in
memory or HDD of CNC. [Series startup] screen can be used to save collectively the stored data
in each actually stored area in the form of binary format.
In [Series startup] screen,
data.
PLC" data,
Loadable compile cycle" data and others can be specified in addition to
"
"
NC" data and
HMI" data. It is benefit for operator that one more data can be specified
"
"
simultaneously.
The data, that can be unload from CNC memory, are stored on the memory after load and they
are stored on HDD after unload. The stored area must be taken into account at making series
startup file.
NC" data specify the memory data and
"
4-2
SINUMERIK
"
HMI" data specify the HDD
"
Hide quick links:
Advertisement
Table of Contents
