Adjusting The Self-Propel Drive - Toro 29732 Operator's Manual
53cm mulching/rear bagging/side discharging lawn mower
Hide thumbs
Also See for 29732:
- Manual (116 pages) ,
- Operator's manual (24 pages) ,
- Operator's manual (20 pages)
Table of Contents
Advertisement
Figure 32
Important:
Position the curved ends of the
blade to point toward the machine housing.
6.
Use a torque wrench to tighten the blade bolt
to 82 N∙m (60 ft-lb).
Important:
A bolt torqued to 82 N∙m (60
ft-lb) is very tight. While holding the blade
with a block of wood, put your weight
behind the ratchet or wrench and tighten the
bolt securely. This bolt is very difficult to
overtighten.
Adjusting the Self-Propel
Drive
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive cable.
1.
Loosen the cable-support nut
g231390
1. 25 to 38 mm (1 to 1-1/2
inches)
2. Self-propel-drive bar
3. Cable jacket
2.
Hold the self-propel-drive bar 25 to 38 mm (1 to
1-1/2 inches) from the handle
3.
Pull down the cable jacket (toward the machine)
until there is no slack in the cable
4.
Tighten the nut on the cable support.
5.
Release the self-propel-drive bar and ensure
that the cable is loose.
Note:
The cable must be loose with the
self-propel drive bar in the released position;
otherwise, the machine may creep when you
disengage the bar.
19
(Figure
33).
Figure 33
4. Cable-support nut
5. Cable support
(Figure
33).
(Figure
g009692
33).
Advertisement
Table of Contents
