Entering A Test Condition In Storage Display - UE Systems Ultraprobe 10,000 Manual

Hide thumbs Also See for Ultraprobe 10,000:

Table of Contents

On the bottom line of the display panel, you will find the Function Select Indicator: "Press Enter

for:" (you can use this to enter any of the following default fields). The default function fields

are:

a. STORE (A)

b. STORE (B)

c. STORE (C)

d. STORE (D)

e. SETUP MENU

f. TEXT EDITOR (ON/OFF)

HOW TO USE THE OPERATIONAL FEATURES

TO ENTER A TEST CONDITION IN STORAGE DISPLAY. Spin to Test, the condition

default is OK and will blink slowly.

If it is necessary to change the test condition:

Click with the Sensitivity Control Dial and the condition (OK) will blink rapidly.

Spin to select a condition indication. The choices are; OK, BAD, NE, CHK (for check).

It is also possible to customize the results codes for other conditions. These codes can

be changed in the Ultratrend DMS software and uploaded to the Ultraprobe.

To Set, Click the Sensitivity Control Dial (the condition

will blink slowly).

Spin to Temperature should a Temperature entry be

desired.

Click on the Temperature setting (it will blink rapidly)

For example, if you are looking to enter a reading of

250; Spin to the left to select the value of "200" and to

the Right to select the value of 50).

Click to set.

Press Enter to store the information or Spin to EXIT

and click to exit.

g. ALARM (DISABLED ENABLED)

h. VALVE INFO

STORAGE DISPLAY

j. RECORD WAV

k. SD INFO (SD Card)

STORE RECORD AND EXIT

Table of Contents