Table of Contents
Advertisement
5. Check the alignment between the cotter pin hole on
the motor shaft and the castle nut openings. Adjust
the castle nut as needed for cotter pin installation.
6. Install the cotter pin in the castle nut (Fig. 190).
Fig 190
7. Install the rear wheel and wheel lug nuts and tighten.
8. Reconnect the battery negative cable to the battery.
9. Check the hydraulic fluid in the reservoir. Add oil
if necessary. Air will need to be purged from the
system. Follow the procedures on Purging the
Hydraulic System, page x-xx.
Z Master Z400 Service Manual
HYDRAULIC SYSTEM
Adjusting the Handle Neutral
If motion control levers do not align, or move easily into
the console notch, adjustment is required. Adjust each
lever, spring and rod separately.
Note: Motion control levers must be installed
correctly. See Installing the Motion Control
Levers in the set up instructions.
1. Lift seat. Install jumper wire in seat switch harness.
2. Disengage the PTO, move the motion control levers
to the neutral locked position and set the parking
brake.
3. Stop the engine, remove the key and wait for all
moving parts to stop before leaving the operating
position.
4. Unlatch the seat and tilt the seat forward.
PICT-0011a
5. Begin with either the left or the right motion control
lever.
6. Move the lever to the neutral position but not locked
(Fig. 191).
1. Neutral locked position 3. Neutral position
2. Control lever
Fig 191
fig 50 G001046
4
4-13
Hide quick links:
Advertisement
Table of Contents
