Siemens SITRANS LUT400 Series Operating Instructions Manual page 367
Hart ultrasonic controllers
Hide thumbs
Also See for SITRANS LUT400 Series:
- Operating instructions manual (330 pages) ,
- Manual (140 pages) ,
- Application manual (16 pages)
Table of Contents
Advertisement
Available languages
Available languages
1.2. Pump Control
Use this wizard to configure pumps if they will be used in your application. Be sure to
first complete the applicable Quick Start Wizard.
a.
Press RIGHT arrow
MENU.
b.
Press RIGHT arrow
c.
Press DOWN arrow
d.
At each step, press DOWN arrow
the next item,
or RIGHT arrow
e.
Scroll to desired item and press RIGHT arrow
DOWN arrow
f.
At any time, you can press UP arrow
the wizard.
Start of Wizard - Pump Control
Note:
The introduction screen is displayed only on the device when using the local
push buttons. This screen is not part of the Quick Start when using SIMATIC PDM.
Shows the type of Wizard to be executed.
Options
Number of Pumps
Select the number of pumps to be used with pump control.
Options
If set to NONE, pump control is disabled.
Relay Pump 1
Selects the relay assigned to Pump 1.
Options
Relay Pump 2
View only. Automatically sets the relay assigned to Pump 2 based on relay selected
for Pump 1 in previous step.
Options
(view only)
Page 54
SITRANS LUT400 (HART) – OPERATING INSTRUCTIONS
to activate PROGRAM mode and open menu level 1: MAIN
to navigate to menu item 1.1.
and RIGHT arrow
to open Edit mode: the current selection is highlighted.
to continue.
CANCEL, START
NONE, 2
Default: NONE
RELAY 2, RELAY 3
Default: RELAY 2
If Relay Pump 1 = RELAY 2, then Relay Pump 2 = RELAY 3
If Relay Pump 1 = RELAY 3, then Relay Pump 2 = RELAY 2
to open Pump Control.
to accept default values and move directly to
to store the change, then press
to go back, or LEFT arrow
to cancel
7ML1998MV01
Hide quick links:
Advertisement
Chapters
Table of Contents
Troubleshooting
