Program Mode Display; Security; Local Operation Enable; Remote Operation Enable - Siemens Sitrans LR 460 Instruction Manual
Hide thumbs
Also See for Sitrans LR 460:
- Quick start manual (197 pages) ,
- Operating instructions manual (187 pages) ,
- Instruction manual (123 pages)
Table of Contents
Advertisement
2.
Edit Mode
only parameter items can be in Edit mode.
Note:
•
In this mode, the Edit Mode icon
•
Pressing a number key enters parameter data.
•
In the case of read-only parameters, no change is permitted.
PROGRAM Mode Display
SITRANS LR 460 continues to monitor In and Out values even when the device is
Note:
in PROGRAM mode.
1 – Menu level
2 – Parameter name
3 – Edit Mode indicator
4 – Value of current parameter
When you activate PROGRAM mode for the first time in any power cycle, the LCD
displays the first menu. If, during the same power cycle, you switch to RUN mode, and
then back to PROGRAM mode, then the LCD will display the menu or item that was last
accessed in PROGRAM mode.
Security
Local operation enable
Local Operation can be enabled or disabled via PDM. Go to Identification > Device > Local
Operation Enable and select the desired setting.
Remote operation enable
Remote Operation can be enabled or disabled via the handheld programmer. To change
the setting:
•
Open Menu level 1: Identification.
•
Scroll down to REMLOCK.
1. Identification
1.2. Configuration
•
To enable programming, set REMLOCK to 0. To disable programming, enter 1.
Page II-28
SITRANS LR 460 (4-20 mA) – INSTRUCTION MANUAL
1.2.3. Remote Lock
appears and flashes.
2
1
1.3.1
SOFT REV
0.01.18
4
3
7ML19985JM01
Advertisement
Table of Contents
