Starter Solenoid; Pto Switch - Toro Z MASTER 2000 Series Service Manual
Hide thumbs
Also See for Z MASTER 2000 Series:
- Service manual (148 pages) ,
- Operator's manual (32 pages) ,
- Setup instructions (8 pages)
Table of Contents
Advertisement
Starter Solenoid
Starter Solenoid Test
PTO Switch
2000 Series Z MASTER® Service Manual
3438-778 Rev A
The solenoid is a remote switch that connects the battery to the starter motor
when the ignition switch is turned to START. The solenoid protects the ignition
switch from the high current drawn by the starter motor.
g336406
1. Disconnect the solenoid from the wiring harness.
2. With a multi-meter set to the OHM or continuity setting, check to ensure that
terminals 1 and 2 are open (no continuity).
3. Apply 12 volts (DC) to terminal 3 and ground terminal 4. Terminals 1 and 2
should now be closed (continuity).
g336407
The PTO switch provides battery voltage from the ignition switch to the PTO
clutch.
As part of the safety interlock system, the PTO switch will prevent the engine
from cranking/starting when in the ON position by preventing the starter solenoid
from grounding through the engine stop relay.
Figure 88
Figure 89
Page 8–9
Electrical: Service and Repairs
Hide quick links:
Advertisement
Chapters
Table of Contents
