Table of Contents
Advertisement
1. Place a drain pan at the rear of the machine.
2. Remove the drain plug from the rear of the
transmission (Figure 31).
Figure 31
1. Check/fill plug
3. Push down on the handle and tip the machine back.
Remove the check/fill plug from the right-hand side
of the transmission (Figure 31).
4. When the fluid is drained, install the drain plug.
5. Place the mower on its drums on a level surface.
6. Fill the transmission with approximately 94 fluid
ounces of the proper type of transmission fluid until
the level reaches the bottom of the check/fill hole;
refer to Checking the Transmission Fluid.
7. Install the check/fill plug.
2. Drain plug
Brake Maintenance
Adjusting the Service/Parking
Brake
If service/park brake slips when operated, an adjustment
is required.
1. Move service/parking brake lever to Off position.
2. To increase cable tension, loosen front cable jam nut
and tighten back cable jam nut (Figure 32) until a
force of 11–14 lb. is required to engage brake. Force
to be measured at lever knob. Do not over adjust,
or brake band may drag.
1. Traction cable
26
Figure 32
2. Service/parking brake
cable
Advertisement
Table of Contents
