Table of Contents
Advertisement
Replacing the Hydraulic Filter
Change the hydraulic filter:
After the first 8 operating hours.
After every 200 operating hours.
Use summer filter above 32 F (0 C)
Use winter filter below 32 F (0 C)
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
Important
Do not substitute automotive oil filter or
severe hydraulic system damage may result.
3. Place drain pan under filter, remove the old filter and
wipe the filter adapter gasket surface clean (Fig. 54).
Figure 53
1. Hydraulic filter
4. Apply a thin coat hydro fluid to the rubber gasket on
the replacement filter (Fig. 54).
5. Install the replacement hydraulic filter onto the filter
adapter. Do not tighten.
6. Fill the hydraulic tank with hydraulic fluid until the
fluid overflows the filter and then turn the oil filter
clockwise until the rubber gasket contacts the filter
adapter, then tighten the filter an additional 1/2 turn
(Fig. 54).
7. Clean up any spilled fluid.
8. Add fluid to the cold level of the baffle in the
hydraulic tank.
9. Start the engine and let it run for about two minutes to
purge air from the system. Stop the engine and check
for leaks. If one or both wheels will not drive, refer
Bleeding Hydraulic System, page 42.
10. Recheck the fluid level while the fluid is warm. The
fluid should be between cold and hot.
11. If required, add fluid to the hydraulic tank. Do not
overfill.
1. Hydraulic filter
2. Gasket
Bleeding the Hydraulic System
The traction system is self bleeding, however, it may be
necessary to bleed the system if fluid is changed or after
work is performed on the system.
1
1. Raise rear of the machine so wheels are off the ground
and support with jack stands.
M–4763
2. Start the engine and run at low idle speed. Engage the
lever and traction on one side and spin the wheel by
hand.
3. When the wheel begins to spin on its own, keep it
engaged until wheel drives smoothly. (minimum
2 minutes)
4. Check hydraulic fluid level and add fluid as required
to maintain proper level.
5. Repeat this procedure on the opposite wheel.
Checking the Hydraulic Lines
After every 100 operating hours, check hydraulic lines and
hoses for leaks, loose fittings, kinked lines, loose
mounting supports, wear, weather and chemical
deterioration. Make necessary repairs before operating.
Note: Keep areas around hydraulic system clean from
grass and debris build up.
42
1
3
2
Figure 54
3. Adapter
m–1256
Advertisement
Table of Contents
