Unloading Transport Units - Siemens 8DA Installation Instructions Manual
Medium-voltage switchgear
Hide thumbs
Also See for 8DA:
- Operating instructions manual (48 pages) ,
- Operating instructions manual (36 pages)
Table of Contents
Advertisement
fåëí~ää~íáçå
Lifting packed transport
units with the crane
Removing transport units
from wooden pallets
Lifting unpacked transport
units with the crane
14
6.4
Unloading transport units
DANGER!
Risk of injury due to transport units falling down. The transport units can slip off the
transport tackle due to the high position of the centre of gravity.
!
Do not stay under suspending loads.
!
Avoid heavy movement of the load.
!
Secure the fixing points of the ropes against slipping off.
ATTENTION!
Parts of the switchgear may be damaged by touching ropes or chains when lifted.
!
Use transport tackle / expander.
To avoid damage and pollution, the transport units should be transported as long as
possible in their original packing. Packed transport units are always lifted with the
wooden pallet.
!
Use transport tackle / expander to prevent the transport units from being damaged
by the ropes.
!
Sling the ropes around the ends of the wooden pallet.
!
Unload the transport units and set them down as close to the switchgear building as
possible in order to avoid unnecessary ways.
!
Move the transport units into the building, if possible on their wooden pallets. Only
remove packing where absolutely necessary in order to keep the switchgear as clean
as possible.
!
Remove plastic sheeting only in the building, right before assembling the transport
units.
Unpack transport units and remove from the pallets only if
• there are only short transportation ways left inside the switchgear building,or
• the transport units can be set down with the crane directly at the switchgear building.
The transport unit is screwed on the pallet. The fixing points for transport are located
behind the front metal cover in the frame and at the rear cross member.
!
Remove the metal covers of the panel frames.
!
Remove all fixing bolts.
To lift the transport unit, two round bars with a diameter of 25 mm are required.
Minimum length of the round bars: Width of transport unit plus 400 mm.
The transport holes for pushing the round bars in are marked on the transport units with
a red symbol.
oÉîáëáçå=MP=G=fkpq^iiqflk=fkpqor`qflkp=Ua^=G=USNJVOTPKV=
Hide quick links:
Advertisement
Table of Contents
