Table of Contents
Advertisement
4. Hold the rail against the outside of the left enclosure
mounting flange and loosely insert the front black hex
screws 4 .
5. Extend the rail outside of the rear enclosure mounting
flange; then, install and tighten both rear black hex
screws 5 .
6. Tighten the two front screws 4 ; then, tighten the
four large screws 3 .
Repeat step 3 on page 55 through step 6 to install
the rail marked "R" on the right side of the enclosure.
7. Slide the expansion unit into the enclosure; then,
remove and discard both white screws and wingnuts
6 from the bezel.
8. Align the bezel locator pins with the expansion unit;
then, secure the bezel and EXP200 with two black
hex screws 7 .
9. Use the two small screws 2 (removed in step 3 on
page 55) to secure the rear of the expansion unit.
10. Install hard drives, fans, and power supplies in the
EXP200 expansion unit.
56
IBM Netfinity EXP15, EXP200, EXP500 HMM
Advertisement
Chapters
Table of Contents
