Keyboard-Controller Board - Dell G15 5525 Service Manual
Hide thumbs
Also See for G15 5525:
- Setup and specifications (24 pages) ,
- Setup and specifications (26 pages) ,
- Setup and specifications (26 pages)
Table of Contents
Advertisement
3. Replace eight screws (M2.5x4) that secure the display-assembly hinges to the palm-rest and keyboard assembly.
4. Turn the display assembly over.
5. Connect the camera cable to the system board.
6. Connect the display cable to the connector on the system board and close the latch to secure the cable.
7. Adhere the tape that secures the display cable to the system board.
8. Route the antenna cables through the routing guides on the fan and adhere the tape that secures the antenna cables to the
system board .
Next steps
1. Install the
wireless
card.
2. Install the
rear
cover.
3. Install the
base
cover.
4. Follow the procedure in
Keyboard-controller board
Removing the keyboard-controller board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the battery.
About this task
The following image(s) indicate the location of the keyboard-controller board and provides a visual representation of the
removal procedure.
Steps
1. Open the latch and disconnect the keyboard-backlight cable from the keyboard-controller board.
2. Open the latch and disconnect the keyboard cable from the keyboard-controller board.
34
Removing and installing components
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
