Table of Contents
Advertisement
9
Power cord set requirements
The wide range input feature of the computer permits it to operate from any line voltage from 100 to
120 volts AC or from 220 to 240 volts AC.
The 3-conductor power cord set included with the computer meets the requirements for use in the
country or region where the equipment is purchased.
Power cord sets for use in other countries or regions must meet the requirements of the country or region
where the computer is used.
Requirements for all countries or regions
The requirements listed below are applicable to all countries or regions:
The length of the power cord set must be at least 1.5 m (5.0 ft) and no more than 2.0 m (6.5 ft).
●
All power cord sets must be approved by an acceptable accredited agency responsible for
●
evaluation in the country or region where the power cord set will be used.
The power cord sets must have a minimum current capacity of 10 amps and a nominal voltage
●
rating of 125 or 250 V AC, as required by each country or region's power system.
The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320
●
Standard Sheet C13 connector for mating with the appliance inlet on the back of the computer.
Requirements for specific countries or regions
Country/region
Australia
Austria
Belgium
Canada
Denmark
Finland
France
Germany
Italy
Japan
The Netherlands
Norway
The People's Republic of China
Accredited agency
EANSW
OVE
CEBC
CSA
DEMKO
FIMKO
UTE
VDE
IMQ
METI
KEMA
NEMKO
CCC
Requirements for all countries or regions
Applicable note number
1
1
1
2
1
1
1
1
1
3
1
1
5
107
Hide quick links:
Advertisement
Table of Contents
