Internal Compactflash Memory Card Installation And Removal - Cisco 2691 Installing And Formatting
Compactflash memory cards
Hide thumbs
Also See for 2691:
- Datasheet (8 pages) ,
- User manual (48 pages) ,
- Quick start manual (29 pages)
Table of Contents
Advertisement
Internal CompactFlash Memory Card Installation and Removal
Removing a CompactFlash Memory Card from an External Slot
Complete the following steps to remove a CompactFlash memory card from an external slot:
If the CF LED is lit or blinking, do not remove the CompactFlash memory card. The router might
Caution
reload, or the CompactFlash memory card can be damaged.
Locate the CompactFlash memory card in its slot in the front panel of the chassis. (See
Step 1
Figure
Move the release button, located next to the slot, to its fully extended position, and press the button to
Step 2
unseat the card.
Carefully pull the card out of the slot.
Step 3
Place the removed CompactFlash memory card on an antistatic surface or in a static shielding bag.
Step 4
Installing a CompactFlash Memory Card in an External Slot
Complete the following steps to install a CompactFlash memory card:
Locate the CompactFlash memory-card slot in the front panel of the chassis. (See
Step 1
and
With the label facing up, insert the connector end of the CompactFlash memory card into the slot until
Step 2
the card is seated in the connector and the release button is pushed out. The card is keyed so that it
cannot be inserted wrong.
Pull the release button out and move it to the left, to latch the card in the slot.
Step 3
Step 4
Refer to the
instructions on formatting the CompactFlash memory card.
Internal CompactFlash Memory Card Installation and Removal
Complete the appropriate procedure below for installing or removing a CompactFlash memory card
mounted internally on the CPU/mainboard. To access the internal CompactFlash memory card, you need
to either remove the chassis cover or slide the CPU/mainboard out, depending on the platform. For
Cisco 2691, Cisco 3631, and Cisco 3725 routers, refer to the
page
If you have questions or need assistance, see the
Internal CompactFlash memory card connectors are located as shown in
and
Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards
4
2, and
Figure
3.)
Figure
3.)
"Formatting Procedures for CompactFlash Memory Cards" section on page 20
9. For Cisco 3745 routers, refer to the
Figure
7.
"Removing the Chassis Cover" section on
"Removing a Plug-in CPU/Mainboard" section on page
"Obtaining Technical Assistance" section on page
March 2002
Figure
1,
Figure
1,
Figure
for
Figure
4,
Figure
5,
Figure
78-13892-03
2,
7.
32.
6,
Advertisement
Table of Contents
