Table of Contents
Advertisement
Operation Manual / TPS44-H.. - TPS52-H..
9 Eliminating malfunctions / 9.1 Malfunctions when starting
9
Eliminating malfunctions
9.1
Malfunctions when starting
Delayed start-up
Possible causes
Turbochar-
Turbocharger contaminated
ger
Bearing damaged
Rotor rubbing
Foreign object in the turbocharger
Table 15: Malfunctions when starting – Delayed start-up
Vibrations
Possible causes
Turbochar-
Rotor unbalance
ger
Turbine or compressor damaged
Bearing damaged
Engine
Vibrations from engine
Table 16: Malfunctions when starting – Vibrations
Rotating parts rubbing
Normal behaviour, not a malfunction
Turbochar-
A minimal and uniform wear on the circumference of the rotor components is
ger
permitted. This wear can be caused by slight local rubbing against adjacent com-
ponents. This causes the compressor or turbine blades to be somewhat
shortened. To prevent significant loss of efficiency, specific tolerances must be
fulfilled.
¡
If there is any doubt about the extent of the rubbing, contact an ABB Tur-
bocharging Service Station.
¡
Have a dimension check carried out by an ABB Turbocharging Service Sta-
tion.
Table 17: Malfunctions when starting - Rotating parts rubbing
© Copyright 2021 ABB. All rights reserved.
Remedy
Clean (see chapter
→53)
ance work
Contact ABB Turbocharging Service
Station
Remedy
Contact ABB Turbocharging Service
Station
Contact enginebuilder
HZTL4037_EN
Periodic mainten-
Rev.G
June 2021
Advertisement
Chapters
Table of Contents
