Table of Contents
Advertisement
Removing the power switch/LED bracket
To remove the power switch/LED bracket, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and all peripheral devices; then, disconnect the power cords
3. Remove the cover (see "Removing the cover" on page 57).
4. Remove the bezel (see "Removing the bezel" on page 59).
5. Note the routing of the power switch/LED bracket cable; then, disconnect it from
6. Press in on the retaining tab and rotate the power switch/LED bracket toward
7. From the front of the power switch/LED bracket, squeeze the spring clips on the
8. Carefully pull the power switch/LED bracket cable out of the server.
9. If you are instructed to return the power switch/LED bracket, follow all
78
IBM xSeries 100 Type 8486: Problem Determination and Service Guide
on page 55.
and all external cables.
the system board (see "System-board internal connectors" on page 8 for the
location of the power switch/LED bracket connector).
the right; then, pull the bracket away from the server.
sides of the front USB connector assembly; then, pull the assembly from inside
the bracket to remove it (see "Removing the front USB connector assembly" on
page 76).
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Retaining tab
Advertisement
Table of Contents
