2 Troubleshooting
2.10 Selectable bay (optical drive) Troubleshooting
The Selectable bay can be installed in this model and the Selectable bay optical drive is
installed as standard. Here explains the troubleshooting for the optical drive.
To check if the optical drive is defective or not, follow the troubleshooting procedures below
as instructed.
Procedure 1
Prepare the tools before the test. (Refer to tools for implementing the Diagnostics procedures
on Chapter 3.)
Execute the CD-ROM/DVD-ROM Test in the Diagnostic Program. Refer to Chapter 3, Tests
and Diagnostics for more information on how to perform the test program.
If any error is detected by the test, go to Procedure 2.
Procedure 2
The optical drive may be disconnected from the System board or faulty. Disassemble the
computer following the steps described in Chapter 4 and perform the following checks:
Check 1
Check 2
Check 3
2-44
Get user manuals:
See SafeManuals.com
Procedure 1:
Diagnostic Test Program Execution Check
Procedure 2:
Connector Check and Replacement Check
Diagnostic Test Program Execution Check
Connector Check and Replacement Check
Make sure the optical drive is firmly connected to the connector CN1810 on the
System board.
If the connection is loose, reconnect it firmly and return to Procedure 1. If there is
still an error, perform Check 2.
The optical drive may be faulty. Replace the optical drive with a new one
following the steps in Chapter 4. If the problem still occurs, perform Check 3.
The System board may be faulty. Replace it with new one following the
instructions in Chapter 4.
[CONFIDENTIAL]
2.10 Selectable bay (optical drive) Troubleshooting
PORTEGE M400 Maintenance Manual (960-541)