Advertisement
2.0
Setting the Address
Figure 2 shows the fifteen annunciator addresses you can
select from when setting the D7030X-S8 address.
Figure 2: Address Settings
Address 1
1 |
2
|
4
|
8
1 |
Address 4
1 |
2
|
4
|
8
1 |
Address 7
1 |
2
|
4
|
8
1 |
Address 10
1 |
2
|
4
|
8
1 |
Address 13
1 |
2
|
4
|
8
1 |
The D7030X-S8 must have a unique address set within
its address pins. This address cannot conflict with other
annunciator addresses or other option bus device
addresses. Program the D7030X-S8 at the control panel
using the Update Bus option in the Programming Mode.
Each address can only support one device.
3.0
Setting the LED Jumpers
Set the LED jumpers to 8 LED (zones) and 8 LED
ENABLED as shown in Figure 3. When adding a D7032
Eight-Zone LED Expander, refer to the D7032
Installation Guide (P/N: 47169) for jumper settings.
Figure 3: Jumper Settings
1
Y
G
B
R
16 LED 8 LED 16 LED ENABLE
1
16 LED 8 LED
1 - 16 LED 8 LED (jumper setting for 8 zones)
2 - 16 LED ENABLED (jumper setting for 8 LEDs
enabled)
Bosch | 11/04 | 48176D
Address 2
Address 3
2
|
4
|
8
1 |
2
|
4
Address 5
Address 6
2
|
4
|
8
1 |
2
|
4
Address 8
Address 9
2
|
4
|
8
1 |
2
|
4
Address 11
Address 12
2
|
4
|
8
1 |
2
|
4
Address 14
Address 15
1 |
2
|
4
2
|
4
|
8
8
8
1
To CTRL-X
2
16 LED ENABLED
D7030X-S8 | Installation Guide | 4.0
4.0
Wiring
Ensure all wiring is de-energized before
routing.
Inform the operator and local AHJ before
|
8
installing the D7030X-S8 in an existing
system. Also, disconnect all power to the
FACP.
|
8
1. Remove AC power from the system at the dedicated
120 VAC breaker.
|
8
2. Remove the standby battery power before making
or removing any connections to the FACP.
|
8
3. Route the wiring from the control panel (Option
Bus A or Option Bus B) through the three-gang box
|
8
knockout and to the annunciator terminal strip
(Figure 4).
Figure 4: D7030X-S8 Terminal Wiring
RA BAGA YA RB BBGB YB
2
1 - Control panel option bus
2 - Option Bus A
Note: Connect to either bus.
To prevent the D7030X-S8 from operating
improperly, do not use Bus A and Bus B
simultaneously. Use one or the other.
1
3
3 - Option Bus B
4 - Terminal strip
Wiring
4
Y
G
B
R
3
Advertisement
