Table of Contents
Advertisement
Setup
Using the app
You can change the name of the camera
using the [HomeHawk] app. For more
information, refer to the User's Guide
(page 32).
Confirming the camera
installation area
Before deciding where to install the camera,
carefully read the chapter "Installation
Location", beginning on page 12, to confirm
the installation location and direction.
Camera installation
Installation precautions
R Do not use an impact driver. (This may lead
to damaged screws or over-tightening.)
R Mount the camera on the stable location
with a height of 2.2 m (7 feet 3 inches)
where the unit can be adequately
supported when installing.
R Do not mount the camera on a soft
material. It may fall down, break or cause
injury.
Wall material information
Siding
R Use the included screws ø4 mm ´ 25 mm
inches ´ 1 inch). Make sure the
(ø
5
/
32
pull-out capacity of each screw is at least
294 N (30 kgf).
R If the weight of the camera is supported by
the siding only, the siding could become
damaged. Make sure you mount the
camera in a location where the structure
behind the siding can be used to support
the weight of the camera. If this is not
possible due to the thickness of the siding,
use commercially-available screws ø4 mm
´ longer than 25 mm (ø
than 1 inch).
For assistance, please visit http://shop.panasonic.com/support
26
HN1007_(en_en)_0308_ver.020.pdf
R Drill a pilot hole using a drill bit that is
Poor example
No support behind
exterior surface
1
2
3
Concrete
R Do not use the included screws. Use screw
R Carefully read the instructions supplied with
R Drill a pilot hole. Remove any debris after
1
2
inches ´ longer
5
/
32
26
appropriate for the type of siding. Remove
any debris after drilling the pilot hole. Do
not drill the pilot hole into the structure
behind the siding.
Ideal example
Structure supports
exterior surface
1
2
Open space, no support
Siding
Structure behind siding
5
anchors (screw ø4 mm (
/
32
designed for concrete walls.
the anchors. Follow instructions regarding
drill bit diameter, hole depth, etc.
drilling the pilot hole.
Mark the hole depth on the drill bit (
and then drill a pilot hole.
1
Remove debris.
3
2
inches))
)
1
2018/03/07
16:48:50
Advertisement
Table of Contents
