Table of Contents
Advertisement
Changing the Engine Oil
Note:
Dispose of the used oil at a recycling center.
1.
Start the engine and let it run for 5 minutes.
Note:
This warms the oil so that it drains better.
2.
Park the machine so that the drain side is slightly
lower than the opposite side to ensure that the
oil drains completely.
3.
Disengage the blade-control switch (PTO) and
engage the parking brake.
4.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
5.
Drain the oil from the engine
(Figure
59).
Figure 59
6.
Slowly pour approximately 80% of the specified
oil into the filler tube and slowly add the
additional oil to bring it to the Full mark
60).
g008804
7.
Start the engine and drive to a flat area.
8.
Check the oil level again.
Changing the Engine-Oil Filter
1.
Drain the oil from the engine; refer to
the Engine Oil (page
2.
Change the engine-oil filter
g027734
46
Figure 60
Changing
46).
(Figure
61).
(Figure
g194610
Advertisement
Table of Contents
