Table of Contents
Advertisement
12.3 Setting a programme
If you wish to change the
automatic detergent or fabric
softener dosage, enter the
AutoDose configuration
mode before proceeding
with any programme setting.
The configuration mode may
cancel temporary settings.
Please refer to "AutoDose
configuration mode"
paragraph in "The AutoDose
Technology (Autodosing)"
chapter.
1. Turn the programme dial to select the
desired washing programme. The
related programme indicator comes
on.
The indicator of the Start/Pause button
flashes.
The display shows an indicative
programme duration, the maximum
declared load for the set programme
(only for a few seconds), the default
temperature, the default spin speed and
the washing phase indicators (when
available).
2. To change the temperature and/or
the spin speed, touch the related
buttons.
3. If desired, set one or more options by
touching the related buttons. The
related indicators come on in the
display and the given information
changes accordingly.
In case a selection is not
possible, no indicator
comes on and an acoustic
signal sounds.
12.4 Starting a programme
with the delay start
1. Touch this repeatedly until the
display shows the desired delay time.
The indicator
2. Touch the Start/Pause button.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts.
comes on.
The ProSense estimation
starts at the end of the
countdown.
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows
3. Touch the Start/Pause button again
to start the programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pause button to
pause the appliance. The related
indicator flashes.
2. Touch the Delay Start button
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pause button again
to start the new countdown.
12.5 Starting a programme
WARNING!
Make sure that the detergent
dispenser is firmly closed,
otherwise programme won't
start.
Touch the Start/Pause button to start the
programme.
The related indicator stops flashing and
stays on.
In the display, the indicator of the
operating phase starts flashing.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
ENGLISH
37
.
Advertisement
Table of Contents
