Toro Z Master Professional 7000 Series Operator's Manual page 48
Riding mower with 132cm or 152cm turbo force side discharge mower
Hide thumbs
Also See for Z Master Professional 7000 Series:
- Operator's manual (364 pages) ,
- Setup instructions (16 pages) ,
- Operator's manual (76 pages)
Table of Contents
Advertisement
Figure 65
1. Clutch
2. Bolts (2) and nuts for the
clutch strap
3. Rubber clutch strap
8. Insert a 0.381–0.533 mm (0.015–0.021 inch) feeler
gauge through one inspection slot in the side of the
assembly. Make sure that it is between the armature
and the rotor friction surfaces
9. Tighten the locknuts until there is slight binding on
the feeler gauge but it can be moved easily within the
air gap
(Figure
66).
10. Repeat this for the remaining slots.
11. Check each slot again and make slight adjustments until
the feeler gauge between the rotor and armature with
very slight contact between them.
Figure 66
1. Slot
2. Adjusting nut
12. Install the clutch to the engine shaft with the key.
13. Apply thread locking adhesive to the center bolt.
14. While holding the crank shaft at the back of the
machine, install the center bolt and torque it to 50
ft-lbs (68 N-m)
(Figure
15. Install the rubber clutch strap to the mower frame with
the two previously removed bolts and nuts
16. Pull up on the spring loaded idler for the PTO drive
belt and install it onto the clutch pulley
4. Clutch center bolt
5. Electrical connection
(Figure
66).
3. Feeler gauge
65).
(Figure
(Figure
64).
17. Plug in the electric connection for the clutch
65).
18. Install the front engine panel.
19. Lower the seat.
65).
48
(Figure
Advertisement
Table of Contents
