Reverse Function; Tone Access - Kenwood TH-22A Instruction Manual
Hide thumbs
Also See for TH-22A:
- Instruction manual (78 pages) ,
- Service manual (58 pages) ,
- Instruction manual (78 pages)
Table of Contents
Advertisement
REVERSE
FUNCTION
Each time [REV] is pressed, the receive frequency is
switched with the transmit frequency.
When used while
monitoring a repeater, it's possible to check the signal
Strength of a station accessing the repeater.
If the
station's signal is strong, it's best to move to a simplex
frequency to continue the contact and free-up the
repeater.
e
If reversal would place the receive frequency outside
the receiver frequency range, an error beep sounds
when [REV] is pressed.
No reversal occurs.
e If the transmit frequency would go out of the
transmitter frequency range if [PTT] were pressed,
then pressing [PTT] causes an error beep and
Receive is selected.
e
Reverse cannot be activated while [PTT] is held
down.
e
Automatic Offset cannot be used while Reverse is ON.
30
TONE ACCESS
Each time [T/CT] is pressed, the Tone and CTCSS
functions are changed as follows:
No indicator ————» T ———-»
CT
(ce eeeeeeresasd
No indicator : Subaudible tone not transmitted and
tone squelch not functional.
T
: Subaudible tone transmitted.
CT
: Subaudible tone transmitted and
tone squelch functional.
Note:
> "CT" will appear if [T/CT] is pressed when the TSU-8
CTCSS module is not installed: however, CTCSS will not
function.
TH-22E/TH-42E only
» When [T/CT] is pressed with 1750 Hz selected, 1750 Hz
tones are transmitted.
"T" appears during this period.
Releasing [T/CT] stops transmission and "T" goes OFF.
> ff {T/CT] is pressed when any frequency other than
1750 Hz is selected, Tone will switch ON and OFF.
» When 1750 Hz is selected while Tone is OFF, pressing
[T/CT] does not change the Tone/CTCSS status.
When
1750 Hz is selected while Tone or CTCSS is ON, 'T' or
"CT" goes OFF.
Advertisement
Table of Contents
