Table of Contents
Advertisement
6. Please inform the delivery service immediately if the package contents are incomplete or
damaged or do not correspond with your order. Fax the enclosed form "SIMATIC IPC/PG
Quality Control Report".
7. Please keep the enclosed documentation in a safe place. It belongs to the device. You need
the documentation when you commission the device for the first time.
8. Write down the identification data of the device.
3.1.2
Built-in devices
3.1.2.1
Permitted mounting positions
The built-in device is intended for installation in:
• Mounting cabinets
• Control cabinets
• Switchboards
• Consoles
In the following, all of these mounting options are referred to by the general term "cabinet".
IFP V2 UL hazardous information
Operating Manual, 11/2023
WARNING
Electric shock and fire hazard due to damaged device
A damaged device can be under hazardous voltage and trigger a fire in the machine or
plant. A damaged device has unpredictable properties and states.
Death or serious injury could occur.
Make sure that the damaged device is not inadvertently installed and put into operation.
Label the damaged device and keep it locked away. Send off the device for immediate
repair.
NOTICE
Damage from condensation
If the device is subjected to low temperatures or extreme fluctuations in temperature
during transportation, as is the case in cold weather, for example, moisture can build up
on or inside the device (condensation).
Moisture causes a short circuit in electrical circuits and damages the device.
In order to prevent damage to the device, proceed as follows:
• Store the device in a dry place.
• Bring the device to room temperature before starting it up.
• Do not expose the device to direct heat radiation from a heating device.
• If condensation develops, wait until the device is completely dry before switching it
on.
Installing and connecting the device
3.1 Preparing for installation
11
Advertisement
Table of Contents
