Advertisement
Recommended
setting
USING YOUR FREEZER
TEMPERATURE CONTROL PANEL
Recommended
setting
PLACEMENT OF THE FREEZER
Before using the freezer, please remove all the package, which includes
the base pad, the foam cushion block in the freezer and adhesive tape, etc.
and tear o the protective lm on the door body and case.
Place the freezer in a well-ventilated indoor area with a at and sturdy ground.
Select the place that is far away from the heat source and direct sunlight.
Do not place it in damp or watery areas to prevent rusting or weakening
the insulation e ect.
The top space of the freezer should be greater than 28" / 70 cm and
the distance between the sides, back of the freezer and the wall should
be greater than 8" / 20 cm, so as to facilitate the opening and closing of
the freezer door and heat dissipation.
After transportation, please let the freezer stand for at least 2 hours before
connecting to the power supply, otherwise it may cause performance
degradation or damage to the freezer.
Before storing fresh or frozen food in the freezer, run the freezer for 2 to 3 hours;
in hot summer days, run the freezer for 4 hours in advance.
During a power outage or cleaning, unplug and plug in again after a 5-minute
interval to prevent damage to the compressor.
The area where the temperature controller knob points
to "COOLING" is the refrigeration area, and "FREEZING" is
the frozen area;
When the temperature controller knob is turned clockwise,
the temperature inside the freezer decreases;
When the temperature controller knob is turned
counterclockwise, the temperature inside the freezer
increases;
At the OFF position: turn o the freezer;
Please refer to the schematic diagram to identify the
"recommended gear".
8
Advertisement
