Table of Contents
Advertisement
1. Remove the drain plug from the oil
pan and allow the fluid to drain into a
suitable container.
2. Using filter wrench remove the main
filter by rotating it anticlockwise.
2
1
1. Filter 2. O-ring 3. Magnet
3. Remove the magnet from the filter
attachment tube or from the top of the
filter element.
4. Clean any metal debris from the
magnet. Report any metal pieces
larger than dust to your maintenance
personnel.
5. Reinstall the magnet onto the filter
attachment tube.
6. Lubricate the O-ring on the control
main filter with transmission fluid.
8. INSPECTION AND MAINTENANCE
7. Install, by hand, the control-main
filter until the O-ring on the control
main filter touches the converter
housing.
8. Turn the filter ONE FULL TURN
ONLY by hand, after O-ring contact.
9. Reinstall the drain plug and sealing
washer. Tightening torque: 30 - 40
N·m {3.1 - 4.1 kgf·m}.
10. After refill, check the fluid level and
add the proper fluid, if necessary.
11. For the fluid check procedure, refer
to "To check the automatic
transmission fluid level - Alison 2500"
in this chapter.
12. Start the engine. Check the filter
and seal for leaks.
8-21
Advertisement
Table of Contents
